Short: Telserial Device 1.40 Install for Xeno Author: X-Team Development Uploader: cgfx xenolink computek net Type: comm/xeno Architecture: m68k-amigaos TELSERIAL DEVICE 1.40 INSTALLATION FOR XENOLINK BBS Attention this is what you need to set up telser.device with Xenolink BBS. I have fully tested this with 6 nodes and it works fine. Note the problem Brendan was getting with the menus getting mangeled I also was getting and I believe this has to do with Term and not Xenolink as I have checked the Ansi ver well Note Xenolink Screen Ansi is Perfect Same time The Ansi/ascii in the menu text is perfect if you telnet in from a shell everything is perfect. but with term there is some small artifacting with the ansi/ascii So I conclude the problem is within Term and not in Xeno or Telser Note to setup 1. Install telser.device 1.40 2. copy the file from the enclosed db into your amitcp:db 3. addon the service line and inet.config lines from the service.addon and inet.config.addon if it already isn't done by the telser installer 4. Edit your Xconfig for your telnet node to match the sample node.config enclosed. and you should be set: CYA, X-Team Development Jack Boling mailto://cgfx@xenolink.computek.net http://www.xenolink.computek.net ftp://ftp.xenolink.computek.net telnet://bbs.xenolink.computek.net snail://PO Box 560831 The Colony, Tx 75056 USA