CORE Working Group P. Urien Internet Draft Telecom Paris Intended status: Experimental June 18 2022 Expires: December 2022 Blockchain Transaction Protocol for Constraint Nodes draft-urien-core-blockchain-transaction-protocol-08.txt Abstract The goal of the blockchain transaction protocol for constraint nodes is to enable the generation of blockchain transactions by constraint nodes, according to the following principles: - transactions are triggered by Provisioning-Messages that include the needed blockchain parameters. - binary encoded transactions are returned in Transaction-Messages, which include sensors/actuators data. Constraint nodes, associated with blockchain addresses, compute the transaction signature. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119. Status of this Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on December 2022. . Urien Expires December 2022 [Page 1] Copyright Notice Copyright (c) 2022 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Urien Expires December 2022 [page 2] Blockchain Transaction Protocol for Constraint Nodes June 2022 Table of Contents Abstract........................................................... 1 Requirements Language.............................................. 1 Status of this Memo................................................ 1 Copyright Notice................................................... 2 1 Overview......................................................... 4 2 Overview of the Blockchain Transaction Protocol for Constraint Nodes.............................................................. 4 2.1 Architecture................................................ 4 2.2 An Ethereum Use Case........................................ 5 3 Blockchain Transaction Protocol Messages Definition.............. 6 3.1 Provisioning Message........................................ 6 3.1.1 Encoding example in JSON syntax ...................... 6 3.2 Transaction Message......................................... 6 3.2.1 Encoding example in JSON syntax ...................... 6 4. Blockchain Transaction Protocol Messages Binary Encoding........ 7 4.1 CoAP messages............................................... 7 4.2 HTTP Messages............................................... 7 5 IANA Considerations.............................................. 7 6 Security Considerations.......................................... 7 6 References....................................................... 7 6.1 Normative References........................................ 7 6.2 Informative References...................................... 7 7 Authors' Addresses............................................... 7 Urien Expires December 2022 [Page 3] Blockchain Transaction Protocol for Constraint Nodes June 2022 1 Overview In the context of this draft sensors/actuators are powered by micro- controllers comprising about 10KB of RAM and 100KB of non volatile memory. The node electronic board may include a radio SoC (System On Chip) or the micro-controller can be part of the SoC. The radio chip manages IP connectivity with another device, typically acting as a controller, which provides a full internet access with standard computing resources. A constraint node driving sensors and/or actuators may deliver critical data dealing with safety (fire detection,...) or legacy (pollution measurement,...) information. Blockchain infrastructure provides two important features in an Internet of Things (IoT) context: - Authentication of data in P2P context. Blockchain signed transactions are checked by numerous nodes. - Information publication. Transactions are stored in duplicated and distributed databases. - Dating information. Transactions are dated during the mining process. The goal of the blockchain transaction protocol for constraint nodes is to enable the generation of blockchain transactions by constraint nodes, according to the following principles: - transactions are triggered by controllers. Needed blockchain parameters are included in provisioning messages. - binary encoded transaction messages are returned by constraint nodes. A node has the ability to compute the transaction signature. 2 Overview of the Blockchain Transaction Protocol for Constraint Nodes 2.1 Architecture <--Provisioning-Message +--------------------+ IP +----------------------+ +------------+ | Constraint Node | link | Controller | | Blockchain | + Blockchain Address +------+ Full IP connectivity +--+ Network | + Private Key | | Access to blockchain | | | +--------------------+ +----------------------+ +------------+ Transaction-Message--> Figure 1. Functional architecture for the Blockchain Transaction Protocol for Constraint Nodes A constraint node holds a blockchain address (BA). The blockchain address is computed from a private key (Pk). Most of today blockchain infrastructures deal with ECDSA signatures, generated Urien Expires December 2022 [Page 4] Blockchain Transaction Protocol for Constraint Nodes June 2022 over the Secp256k1 elliptic curve. The private key is a 32 bytes number, stored in the constraint node. The computation of hash procedures such a SHA2 or KECCAK-256 can be handled by microcontrollers. Although ECDSA signature may be generated by a microcontroller, a tamper resistant resource could be used, either embedded in the CPU, or in a chip such as a secure element[ISO7816]. As an illustration an architecture based on micro-controller, radio SoC and secure element was demonstrated in [IEEE-CCNC2018]. The controller is a device with full IP connectivity. It typically communicates with the constraint node thanks to the CoAP [RFC7252] protocol, or other legacy protocols such as HTTPS. The controller has access to the blockchain infrastructure, to which it is able to forward a binary encoded transaction, signed by the constraint node. 2.2 An Ethereum Use Case. The following figure 2, illustrates an Ethereum transaction generated by a constraint node, whose total length is 118 bytes. F8 74 // RLP List, length= 116 bytes 0C // nonce 1 byte =12 decimal 85 06FC23AC00 // gasPrice = 30 GWei 83 013880 // gasLimit = 80000 gas // recipient address 20 bytes 94 6BAC1B75185D9051AF740AB909F81C71BBB221A6 80 // Null Ether Value // Data 15 bytes "Temperature=25C" 8F 54656D70657261747572653D323543 1B // recovery parameter, 1 byte A0 // r, 32 bytes, ECDSA r parameter A9B58980F76EE6284800B82A2B5DF13E456887EC0CF426A5E5D6A738EB1784ED A0 // s, 32 bytes, ECDSA s parameter 629633C6A3ED5FEE0FB40E2D1CF251345B885D372857B1A6C4762C9BE914281F Figure 2. Illustration of an Ethereum transaction, generated by a constraint node. The identifier (TxId) of this transaction (i.e. its KECCAK-256 digest) is: 0xd6904d832462ae17718c69e9caa0c3f3bed458382ac1f4e43b1aadd8e94744ad Given this TxId, the transaction can be retrieved in any Ethereum blockchain database, like for example: https://etherscan.io/tx/0xd6904d832462ae17718c69e9caa0c3f3bed458382a c1f4e43b1aadd8e94744ad The transaction date (20-2018 09:52:42 PM +UTC) is published and certified by the blockchain. Urien Expires December 2022 [Page 5] Blockchain Transaction Protocol for Constraint Nodes June 2022 The binary encoded transaction comprises two parts, - information relying on the Ethereum blockchain context, such as the nonce, the gasPrice, the gasLimit, the recipient address, and an Ether value. - information delivered by the constraint node, data (a temperature measurement), and the ECDSA signature computed from the 32 bytes private key. Parameters relying on the Ethereum blockchain context MUST be included in the Provisioning-Message. The signed transaction MUST be included in the Transaction-Message. 3 Blockchain Transaction Protocol Messages Definition The Blockchain Transaction Protocol comprises two messages, to be included in transport protocols, such as CoAP or HTTP. 3.1 Provisioning Message This message includes the following attributes : - A type, an integer value, specifying the message content. - An ordered list of values, storing the parameters of the blockchain context. 3.1.1 Encoding example in JSON syntax Here is an illustration of the provisioning message associated to the Ethereum blockchain. { "type": 1, "nonce": 12, "gasPrice": 30, "gasLimit": 80000, "address": "6BAC1B75185D9051AF740AB909F81C71BBB221A6", "value": 0 } 3.2 Transaction Message This message include the following attributes - A type, an integer value, specifying the message content. The zero value indicates an error. - The binary encoded transaction, including the signature. 3.2.1 Encoding example in JSON syntax Here is an illustration of the transaction message associated to the Ethereum blockchain. Urien Expires December 2022 [Page 6] Blockchain Transaction Protocol for Constraint Nodes June 2022 { "type": 1, "transaction": "F8740C8506FC23AC0083013880946BAC1B75185D9051AF740AB909F81C71BBB221A 6808F54656D70657261747572653D3235431BA0A9B58980F76EE6284800B82A2B5DF 13E456887EC0CF426A5E5D6A738EB1784EDA0629633C6A3ED5FEE0FB40E2D1CF2513 45B885D372857B1A6C4762C9BE914281F" } 4. Blockchain Transaction Protocol Messages Binary Encoding 4.1 CoAP messages To be Done 4.2 HTTP Messages To be Done 5 IANA Considerations TODO 6 Security Considerations TODO 6 References 6.1 Normative References [RFC7252] Shelby, Z., Hartke, K., and C. Bormann, "The Constrained Application Protocol (CoAP)", RFC 7252, June 2014. [ISO7816] ISO 7816, "Cards Identification - Integrated Circuit Cards with Contacts", The International Organization for Standardization (ISO). 6.2 Informative References [IEEE-CCNC2018] Urien,P., "An Innovative Security Architecture for Low Cost Low Power IoT Devices Based on Secure Elements", IEEE CCNC 2018 7 Authors' Addresses Pascal Urien Telecom Paris 19 place Marguerite Perey 91120 Palaiseau Phone: NA France Email: Pascal.Urien@telecom-paris.fr Urien Expires December 2022 [Page 7]